Instructions for use
- Mix the contents of a bag with 4-7 litres of water (the desired consistency can be adjusted by adding water) for 5 minutes twice.
- The texture of the material must be suitable for applying on walls with a masonry pan.
- Apply the watertight mortar on the wall and thoroughly incorporate in all parts of the structure using a whitewash or wide brush.
- For larger surfaces, the mortar can be applied by spraying. (Recommended sprayer: Graco RTX 1500).
- Apply the Oxydtron Watertight and Repair Mortar in 2-3 layers.
- No more than 3-4 hours should elapse between applying the first two layers.
- Apply the third layer to the structure within no more than 24 hours, using a notched trowel.
- The total thickness of the applied layers will be 0.8-1 cm.
- The connection point of the insulated masonry and the associated screed is also to be sealed.
- In the case of uneven masonry, the Oxydtron Watertight and Repair Mortar must be covered with a surface filler/smoothing plaster. The use of the Oxydtron Renova mortar is the most suitable for this purpose.
- If the treated structure is to be subsequently covered with a surface filler plaster, it should be sprayed with Oxydtron Renova plaster after using the Oxydtron Watertight and Repair Mortar (based on the wet-on-wet principle).
- When not applying an aesthetic plaster, the material can be smoothed by itself.
- When repairing concrete, the chiseled cracks/concrete defects are filled in stages (maximum 1.5 cm/layer) and all layers are poured into the structure during the initial bonding phase as described above.
